User's Manual

Advanced Configuration
Parameter Description
Frequency Domain A valid frequency domain must be set before the device can be configured with any other
parameters. Selecting a frequency domain makes the device compliant with the allowed
frequency bands and channels for that regulatory domain. See Frequency Domain.
Network Mode The device can be configured in two network modes: Bridge and Routing. By default, the
network mode is Bridge mode.
Active Network Mode A change in the network mode (either Bridge or Routing mode) is applied on the device
only when the device is rebooted.
So, when the network mode is changed and the device is not rebooted, this parameter
displays the current operating network mode of the device.
Maximum MTU Largest size of the data packet that can be sent to/from the Ethernet interface of the
(Maximum device. By default, the MTU size is 1500 bytes. It can be configured with any value ranging
Transmission Unit) from 1500 to 2048 bytes. The MTU size excludes Ethernet Header(14 bytes) + Frame
Check Sequence (4 bytes) + VLAN Tag(4 bytes).
:
• Not all devices support this parameter.
• MTU is configurable only in Tsunami® MP-8150-CPE, Tsunami® MP-8160-CPE
and Tsunami® QB-8150-EPR-12/50 devices.
• For optimal performance, MTU should be configured same on both local and
remote devices.
• By default, Maximum MTU for Tsunami® MP-8100-BSU, Tsunami®
MP-8100-SUA, MP-8150-SUR, Tsunami® MP-8160-BSU, Tsunami®
MP-8160-SUA, Tsunami® QB-8100-EPA, Tsunami® QB-8150-EPR is not
configurable and set to 1500 excluding Ethernet Header(14 bytes) + Frame
Check Sequence (4 bytes) + VLAN Tag(4 bytes).
Frequency Filter Lower These parameters enable you to define the lower and upper frequency band edges, which
Edge, and helps to limit the available frequency band, for a given frequency domain, to a smaller
Frequency Filter Upper
band. By limiting the frequency band, the time taken by a device to scan and connect to
Edge
any other device in the network is reduced.
You can enter frequencies ranging from 0 to 10000 MHz. By default the lower frequency is
set to 0 MHz and higher frequency is set to 10000 MHz.
After configuring the required parameters, click OK, COMMIT and then REBOOT.
5.2 Network
The Network tab allows you to view and configure the network specific information of the device.
To view the current operating network mode of the device, navigate to ADVANCED CONFIGURATION > Network. If the
network mode of the device is configured in Bridge mode, then following screen appears:
Tsunami® 8100 Series - Software Management Guide 35