User's Manual

5
Advanced Configuration
The ADVANCED CONFIGURATION tab provides a means to configure the following advanced features of the device:
• System
• Network
• Ethernet
• Wireless
• Security
• Quality of Service (QoS)
• RADIUS Based SU QoS Configuration
• VLAN (Bridge Mode Only)
• RADIUS Based SU VLAN Configuration
• Filtering (Bridge Only)
• DHCP
• IGMP Snooping
• Routing Mode Features
5.1 System
The System tab enables you to configure system specific information.
To configure system specific parameters, navigate to ADVANCED CONFIGURATION > System. The System screen appears:
Figure 5-1 System Configuration
Tabulated below is the table which explains System parameters and the method to configure the configurable parameter(s):
Parameter Description
Radio Mode Represents the radio mode of the device. Based on the device, the radio mode is set to
either BSU, SU, End Point A or End Point B. In case of a BSU device, you can toggle
between BSU and SU modes. Similarly in case of End Point A or End Point B device, you can
toggle between End Point A and End Point B. But note that a change in radio mode will reset
wireless and WORP parameters of the device after reboot.
Tsunami® 8100 Series - Software Management Guide 34