User's Manual

Basic Configuration
Parameter Description
DDRS Status Applicable only when Dynamic Data Rate Selection (DDRS) is enabled on the device. It
indicates that DDRS is enabled on the device. See DDRS.
Tx Rate Applicable only when Dynamic Data Rate Selection (DDRS) is disabled on the device. This
parameter represents the data transmission rate of the device. You can configure the
appropriate data rate based on the signal level.
: A change in Channel Bandwidth will reset the Tx Rate to default value.
Network Name Network name to identify a wireless network. The network name can be of minimum 2 or
maximum 32 characters. The default network name is MY_NETWORK.
: For a BSU and SU to establish a wireless link, both should in the same network. The
same applies to End Point A and End Point B as well.
Legacy Mode Applicable only to Tsunami® MP-8100-BSU device.
When enabled, allows the device to operate with the legacy products of the Tsunami® MP.11
family such as: MP.11 5054 series, 5012 series, 2454 series and so on. By default, this
parameter is disabled.
BSU / End Point A Applicable only to a SU/End Point B device.
Name
Represents the BSU/End Point A name to which SU/End Point B is connected.
IP Configuration, and See Network.
Default Gateway IP
Address
After configuring the required parameters, click OK and then COMMIT.
: Reboot the device, if you have configured any of the parameters with an asterisk symbol marked against them.
Tsunami® 8100 Series - Software Management Guide 33