User's Manual

Device Initialization
3.2.3 REBOOT
Reboot operation is required for any change in the key parameters to take effect. For example, settings such as configuring the
Radio Mode, IP Address, and Network Mode need reboot to take effect.
It is recommended that the device must be rebooted immediately after modifying a rebootable parameter. On clicking Reboot,
system displays a confirmation window, as shown below.
Figure 3-8 Reboot
: It is always mandatory to commit the changes before REBOOT, otherwise the changes will not take effect. To
reboot the device, click OK.
3.3 Factory Default Configuration
Parameter BSU Mode/ SU Mode/
End Point A End Point B
User Password Public Public
System Name System-Name System-Name
Network Mode Bridge Bridge
Routing Disabled Disabled
IP Address 169.254.128.132 169.254.128.132
Subnet Mask 255.255.255.0 255.255.255.0
Address Type Static Static
Gateway IP Address 169.254.128.132 169.254.128.132
Network Name MY_NETWORK MY_NETWORK
Maximum Number of SUs (per BSU) As per license Not Applicable
Registration Timeout 10 Seconds 10 Seconds
DDRS Enabled Enabled
Input Bandwidth Limit As per license As per license
Output Band Limit As per license As per license
Security Profile Enabled with profile name Enabled with profile name
“WORP Security” “WORP Security”
Tsunami® 8100 Series - Software Management Guide 27