User's Manual

Troubleshooting
8. Enter the network’s Gateway IP Address, if necessary. You may need to contact your Network Administrator to get
this address. You need to enter the default gateway address (169.254.128.133) only if the device and the TFTP server
are separated by a router.
9. By default, the IP address of the TFTP server is provided.
10. By default, the image file name is provided.
11. Click OK. The device will reboot and the download starts automatically.
12. Click OK when prompted to return to the Scan List screen after the device has been updated successfully.
13. Click Cancel to close the ScanTool.
When the download process is complete, start configuring the device.
8.9.3.2 Download a New Image Using the Bootloader CLI
To download the new device image, you will need an Ethernet connection to the computer on which the TFTP server resides. This
can be any computer on the LAN or connected to the device with an Ethernet cable.
You must also connect the device to a computer with a standard serial cable and use a terminal client. From the terminal, enter
the CLI commands to set the IP address of the device and to download the device image.
Preparing to Download the device image
Before starting, you need to know the device IP Address, Subnet Mask, the TFTP Server IP Address, and the device image file
name. Make sure the TFTP server is running and configured to point to the default directory containing the image to be
downloaded.
Download Procedure
1. Download the latest software from http://support.proxim.com.
2. Copy the latest software updates to your TFTP server’s default directory.
3. Connect the device serial port to your computer’s serial port.
4. Open your terminal emulator program and set the following connection properties:
• Com Port: COM1, COM2 and so on, depending on your computer
• Baud Rate: 115200
• Data Bits: 8
• Stop Bits: 1
• Flow Control: None
• Parity: None
5. Under File > Properties > Settings > ASCII Setup, enable the Send line ends with line feeds option.
Terminal Emulator program sends a line return at the end of each line of code.
The terminal display shows Power On Self Tests (POST) activity. After approximately 30 seconds, a message indicates:
Starting ScanTool interface, press any key to enter CLI 5”. After this message appears, press any key. Now the
bootloader prompt appears as below:
Bootloader=>
6. Enter the following commands:
Bootloader=> show (to view configuration parameters and values)
Bootloader=> set ipaddr <Access Point IP Address>
Bootloader=> set serverip <TFTP Server IP Address>
Bootloader=> set filename <Device Image File Name, including file extension>
Bootloader=> set gatewayip <Gateway Ip Address>
Bootloader=> set netmask <Network Mask>
Bootloader=> set ipaddrtype static
Bootloader=> show (to confirm your new settings)
Tsunami® 8100 Series - Software Management Guide 215