User's Manual

Monitor
Figure 7-28 Debug Log
Features: Select the appropriate features to be logged. The available features are Select All, DDRS Level 1, DDRS Level 2,
DDRS
Level 3 and DFS.
File Status: This parameter displays the current size of the Debug Log file.
After selecting the DDRS level, click OK.
To delete the Debug Log, click Clear Log.
To get the updated status of the Debug Log File, Click Refresh.
7.9.4 Temperature Log
: Temperature Log are not applicable to Tsunami® MP-8150-CPE, Tsunami® MP-8160-CPE and Tsunami®
QB-8150-EPR-12/50 devices.
Temperature Log feature reports and logs the internal temperature of the device. When the internal temperature value
reaches the minimum threshold value of -40ºC or the maximum threshold temperature of 60ºC, the internal temperature is
logged and an SNMP trap is sent (At 5 Degrees before each limit, the device issues a warning trap). These threshold
temperature values may be reconfigured but the values cannot exceed beyond the default values.
: A recording interval from one to sixty minutes with 5-minute increments can be selected. If we configure the logging
interval as “0”, temperature logs will be disabled.
To view and configure threshold values, and the logging interval, navigate to MONITOR > Logs > Temperature Log.
The threshold values of temperature are configured in Centigrade (Celsius) scale. The Temperature Log screen displays the
Current Device Temperature in Celsius, along with High Temperature and Low Temperature Threshold values and
Temperature Logging Interval. The temperature log can have a maximum size of 65 Kb; and once the limit is reached, only the
last 576 logs are available. (Log storage is up to six days with the refresh time of 5 minutes).
Tsunami® 8100 Series - Software Management Guide 197