User's Manual

Monitor
7.2.2 SU / End Point B Link Statistics
: SU Link Statistics is applicable only to a BSU, and End Point B Link Statistics is applicable only to a End Point A device.
SU Link statistics provides information about the SUs connected to a BSU. Similarly, End Point B Link Statistics provides
information about an End Point B currently connected to an End Point A device.
To view link statistics, navigate to MONITOR > WORP Statistics > Interface 1 > SU / End Point B Link Statistics.
Figure 7-9 An Example - SU Link Statistics
Tabulated below is an explanation to each of these parameters:
Parameter Description
SU Name/ Represents the name of the SU/End Point B connected to a BSU/End Point A respectively.
End Point B Name
MAC Address Represents the MAC address of the SU/End Point B connected to a BSU/End Point A
respectively.
Local Tx Rate (Mbps) Represents the data transmission rate at the local (current device) end.
Remote Tx Rate Represents the data transmission rate at the remote (peer) end.
(Mbps)
Local Antenna Port Indicates the status of the antenna ports at the local end. The following symbols indicate
Info the status of the antenna ports.
Indicates the antenna port is disabled.
Indicates the antenna port is enabled and signal is present.
Local Signal (dBm) Represents the signal level with which the device at the local end receives frames from the
device at the remote end, through wireless medium.
Local Noise (dBm) Represents the noise measured at the local end antenna ports.
Local SNR (dB) Represents the SNR measured by the receiver at the local end and is based on the Local
Signal and Local Noise.
Tsunami® 8100 Series - Software Management Guide 181