User's Manual

Management
Parameter Description
ReSync Interval Set ReSync time interval ranging from 0 to 1440 minutes. Once the time is synchronized,
the SNTP Client tries to resynchronize with the time servers after every set time interval.
Sync Status Specifies the SNTP Client sync status when it tries to ReSync again with the time servers.
The status is as follows:
• Disabled: The SNTP client will not synchronize the time with the time servers and
displays the status as Disabled.
• Synchronizing: The SNTP client is in the process of synchronzing time with the time
servers.
• Synchronized: The SNTP client has synchronized time with the time servers.
Current Date/Time Displays the current date and time.
If SNTP is enabled, it displays the time the device received from the SNTP server. If SNTP is
not enabled, then it displays the time manually set by the user.
Manual Time If SNTP Client is disabled on the device or the time servers are not available on the
Configuration network, then the user can manually set the time. Enter the time manually in the format:
MM-DD-YYYY HH:MM:SS.
:
• Manual time configuration is not retained across reboots. After every reboot the
user has to set the time again.
• With manual time configuration, the device may lag behind the actual time
over a period of time. So, it is recommended to periodically check and adjust
the time.
To save the configured parameters, click Ok and then COMMIT.
6.5 Access Control
The Access Control tab enables you to control the device management access through specified host(s). You can specify a
maximum of 5 hosts to control device management access.
To configure management access control parameters, navigate to MANAGEMENT > Access Control. The Management
Access Control screen appears:
Tsunami® 8100 Series - Software Management Guide 169