User's Manual

Management
Figure 6-20 Time Synchronization
Tabulated below is the table which explains SNTP parameters and the method to configure the configurable parameter(s):
Parameter Description
Enable SNTP Status Select this parameter to enable SNTP Client on the device. If enabled, the SNTP Client tries
to synchronize the device’s time with the configured time servers.
By default, the SNTP status is disabled.
Primary Server IP Enter the host name or the IP address of the primary SNTP time server. The SNTP Client
Address/Domain tries to synchronize device’s time with the configured primary server time.
Name
: If host name is configured, instead of IP address then make sure that DNS server
IP is configured on the device.
Secondary Server IP Enter the host name or the IP address of the secondary SNTP time server. If the primary
Address/Domain server is not reachable, then SNTP client tries to synchronize device’s time with the
Name secondary server time.
: If the SNTP Client is not able to sychronize the time with both the servers
(primary and secondary), then it tries to synchronize again after every one
minute.
Time Zone Configure the time zone from the available list. This configured time zone is considered
before setting the time, received from the time servers, on the device.
Day Light Saving Time Configure the Day Light Saving time from the available list. This configured Day Light
Saving time is considered before setting the time, received from the time servers, on the
device.
Tsunami® 8100 Series - Software Management Guide 168