User's Manual

Management
Figure 6-16 SNMPv3
Tabulated below is the table which explains SNMP parameters and the method to configure the configurable parameter(s):
Parameter Description
SNMP By default, the user has the access to manage the device through SNMP Interface. To
prevent access to the device through SNMP, select Disable.
: Any change in the SNMP status will affect the Network Management System
access.
Version Allows you to configure the SNMP version. The supported SNMP versions are v1-v2c and
v3. By default, the SNMP version is v1-v2c.
SNMP v1-v2c Specific Parameters
Read Password Represents the read only community string used in SNMP Protocol. It is sent along with
each SNMP GET / WALK / GETNEXT / GETBULK request to allow or deny access to the
device. This password should be same as read password set at the NMS or MIB browser.
The default password is “public”. The password should be of minimum 6 and maximum
32 characters.
: The following special characters are not allowed in the password:
- = \ “ ‘ ? / space
Tsunami® 8100 Series - Software Management Guide 163