User's Manual

Advanced Configuration
To configure the static routing table, navigate to ADVANCED CONFIGURATION > Network > Static Route Table. The Static
Route Table screen appears.
Figure 5-81 Static Route Table
Tabulated below is the table which explains Static Route Table entries and the method to configure the configurable
parameter(s):
Parameter Description
Static Route Status If Static Route Status is enabled, the packets are sent as per route configured in the static
routing table. If disabled, forwards the packet to the default gateway.
Destination Address Represents the destination IP address to which the data has to be routed.
Subnet Mask Represents the subnet mask of the destination IP address to which the data has to be
routed.
Route Next Hop Represents the IP address of the next hop to reach the destination IP address. Next hop IP
should belong to at least one of the subnets connected to the device.
Admin Metric It is a metric that specifies the distance to the destination IP address, usually counted in
hops. The lower the metric, the better. The metrics can range from 0 to 16.
Entry Status If enabled, considers the packets for routing. If disabled, forwards the packet to the
default gateway.
Tsunami® 8100 Series - Software Management Guide 131