User's Manual

Advanced Configuration
:
• Tsunami® devices supports only passive IGMP Snooping.
• IGMP versions v1,v2 and v3 are supported.
• The device can add a maximum of 64 Multicast groups in the Snooping table.
To configure IGMP Snooping parameters, navigate to ADVANCED CONFIGURATION > IGMP Snooping. The following IGMP
Snooping screen appears:
Figure 5-80 IGMP Snooping
Tabulated below is the table which explains IGMP Snooping parameters and the method to configure the configurable
parameter(s):
Parameter Description
IGMP Snooping Status By default, IGMP Snooping Status is disabled on the device, meaning which, the device
transmits IP multicast traffic to all the ports. To forward the traffic only to the members of
the specific multicast group, enable IGMP Snooping Status.
IGMP Membership Represents the time after which the IGMP multicast group age-outs or elapses. It ranges
Aging Timer
from 135 to 635 seconds. The default Aging Timer is 260 seconds.
IGMP Router Port Represents the time after which the IGMP Router port age-outs or elapses. It ranges from
Aging Timer
260 to 635 seconds. The default Aging Timer is 300 seconds.
IGMP Forced Flood If you select Yes, all the unregistered IPv4 multicast traffic (with destination address which
does not match any of the groups announced in earlier IGMP Membership reports) and
IGMP Membership Reports will be flooded to all the ports. By default, IGMP Forced Flood
is set to No.
After configuring the required parameters, click OK and then COMMIT.
5.13 Routing Mode Features
This section provides an overview of all the features applicable in routing mode only.
5.13.1 Static Route Table
The Static Route Table stores the route to various destinations in the network. When packets are to be routed, the routing table
is referred for the destination address.
Tsunami® 8100 Series - Software Management Guide 130