User's Manual

Advanced Configuration
: A maximum of five pool entries can be added to the table. A pool entry can be deleted but cannot be edited.
5.11.1.1 Adding a New Pool Entry
To add a new entry to the DHCP Pool, click Add on the DHCP Pool screen. The following DHCP Pool Table Add Row screen
appears:
Figure 5-75 DHCP Pool Table Add Row
Enter the pool details and click Add. The entry will be updated in the DHCP pool table. To
apply the configured changes, click COMMIT.
5.11.2 DHCP Server
If DHCP Server is enabled, it picks automatically the IP addresses from the specific interface address pool and assigns them to the
respective DHCP clients.
DHCP Server feature is applicable to both Bridge and Routing Mode. In Routing mode, DHCP Server can be configured for each
interface (Ethernet and Wireless) separately. Unless the DHCP Server functionality is enabled for an interface, the DHCP Server
does not respond to the DHCP requests received on that interface.
To configure the DHCP server parameters, navigate to ADVANCED CONFIGURATION > DHCP > DHCP Server > Interface. The
DHCP Server screen appears:
Figure 5-76 DHCP Server
Tsunami® 8100 Series - Software Management Guide 126