User's Manual

Advanced Configuration
Figure 5-67 TCP/UDP Port Filter
The Filter Control parameters determines if filter has to be applied or not on a TCP/UDP Port. By default, it is disabled. To apply
filters, select Enable and click OK.
5.10.4.1 TCP/UDP Port Filter Table
The TCP/UDP Port Filter table displays a list of default TCP/UDP ports and user-defined ports which can be enabled or disabled as
desired. By default, the device support 7 default TCP/UDP port filter entries.
Parameter Description
Protocol Name The name of the service/protocol. Please note that the system throws an error when an
attempt is made to edit the default service/protocol name.
Port Number Represents the destination port number. Please note that the system throws an error when
an attempt is made to edit the port number.
Port Type Represents the port type (TCP, UDP, Both).
Filter Interface Represents the interface on which the filter is applied. The supported interfaces are,
• Only Ethernet
• Only Wireless
• All Interfaces
Entry Status Set the entry status as either Enable, Disable or Delete.
• Enable: Filter is applied and filters the packet based on the Port number and port
type.
• Disable: No filter is applied.
• Delete: Allows to delete only user-defined TCP/UDP port filter entry. When you
attempt to delete default entries, the device throws an error.
Tsunami® 8100 Series - Software Management Guide 119