Manualshelf

User's Manual

ManualsBrandsProxim Wireless ManualsElectronicsTsunami 8000 Point-to-Point and Point-to-multipoint Product
111112113114115116117118119120
Advanced Configuration
The Advanced Filtering table contains a list of 5 pre-defined protocols on which Advanced Filtering is applied. The following table
explains the Filtering table parameters:
Parameter Description
Protocol Name Represent the protocol name. By default, Advanced Filtering is supported on the following
5 default protocols:
• Deny IPX RIP
• Deny IPX SAP
• Deny IPX LSP
• Deny IP Broadcasts
• Deny IP Multicasts
Direction Represents the direction of an IP Protocol traffic that needs to be filtered. The directions
that can be filtered are,
• Ethernet to wireless
• Wireless to ethernet
• Both
Entry Status If enabled, then filtering is applied on the IP protocol else not applied.
:
• The Advanced Filtering table contains a maximum of 5 pre-defined IP protocols.
• User-defined IP protocols cannot be added to the Advanced Filtering table.
5.10.3.1 Edit Advanced Filtering Table Entries
To edit Advanced Filtering table protocols, click Edit in the Advanced Filtering screen. The Advanced Filtering - Edit Entries
screen appears.
Tsunami® 8100 Series - Software Management Guide 117