Manualshelf

User's Manual

ManualsBrandsProxim Wireless ManualsElectronicsTsunami 8000 Point-to-Point and Point-to-multipoint Product
111112113114115116117118119120
Advanced Configuration
Tabulated below is the table which explains Static MAC Address Filter parameters and the method to configure the
configurable parameter(s):
Parameter Description
Wired MAC Address Specifies the MAC address of the device on the wired network that is restricted from
communicating with a device in the wireless network.
Wired MAC Mask Specifies the range of MAC address to which this filter is to be applied.
Wireless MAC address Specifies the MAC address of the device on the wireless network that is restricted from
communicating with a device in the wired network.
Wireless MAC Mask Specifies the range of MAC address to which this filter is to be applied.
Comment Specifies the comment associated with Static MAC Filter table entry.
Status Specifies the status of the newly created filter.
Click Add and then COMMIT.
:
• A maximum of 200 MAC address filters can be added.
• The Wired MAC address and the Wireless MAC address should be a unicast MAC address.
• The MAC Address or Mask includes 12 hexadecimal digits (each hexadecimal equals to 4 bits containing 0 or 1)
which is equivalent to 48 bit identifier.
5.10.3 Advanced Filtering
With Advanced Filtering, you can filter pre-defined IP Protocol traffic on the network.
By default, 5 IP protocols are pre-defined and based on the configuration they can be blocked or allowed to enter the
network.
To apply filters on the IP protocols, navigate to ADVANCED CONFIGURATION > Filtering > Advanced Filtering. The
Advanced Filtering screen appears:
Figure 5-65 Advanced Filtering
Tsunami® 8100 Series - Software Management Guide 116