User's Manual

Advanced Configuration
Parameter Description
Allow Untagged Select Enable or Disable. By default, it is disabled.
Frames
• Disable: If this option is selected, the Ethernet interface forwards only tagged
frames whose VLAN Id matches with a VLAN ID present in trunk table.
• Enable:
- In case of a BSU, when Allow Untagged Frames is enabled, the Ethernet
interface of the device forwards the data packets as-is.
- In case of a SU/End Point A/End Point B, when Allow Untagged Frames is
enabled, the device behaves as in Access mode. Click OK.
Port VLAN ID Enter the Port VLAN ID in the Port VLAN ID box. The untagged data frames received at
the Ethernet interface are tagged with this port VLAN Id and then forwarded to the
destination interface. By default, the Port VLAN Id is set to -1 which indicates no tag is
added to the data frame. To set Port VLAN tag to the data frame, enter a value ranging from
1 to 4094.
:
• Applicable only on a SU, End Point A and End Point B.
• When Double VLAN is enabled on the device, the Port VLAN ID should not be set
to -1.
• The configured Port VLAN Id should not exist in the Trunk table.
Port VLAN Priority This parameter is used to set IEEE 802.1p priority for the data frames. By default, the
priority is set to 0. To set the Port VLAN priority, enter a value ranging from 0 to 7.
: Applicable only to SU and End Point devices.
After configuring the required parameters, click OK and then COMMIT. Add
VLAN IDs to Trunk Table
To add VLAN IDs to the trunk table,
1. Click Add in the VLAN Ethernet Configuration screen. The VLAN Trunk Table Add Row screen appears.
Figure 5-58 Add VLAN IDs to Trunk Table
Tsunami® 8100 Series - Software Management Guide 106