User Manual

INSTALLATION AND MAINTENANCE MANUAL
LYNX.sc E1 FAMILY
SPREAD SPECTRUM RADIOS
OCTOBER 1998
SECTION 5: APPENDICES PAGE 5-3
Appendix B - Rear Panel DIP Switches
The LYNX.sc radio has two separate eight-segment rear panel DIP switches, labeled SW1, and
SW3. Upon shipment from the factory, these switches are set for factory default configuration,
which is all switches down (in the “zero” position), except for SW3 positions 5 through 8, which are
set to match the installed rear panel RF filter assembly (which determines the frequency channel
for transmit and receive, such as A1, A2, B1, B2, etc.). The tables in this section provide a quick
reference for the DIP switch functions and their settings.
DIP switch settings are noted by their position, either up (1), or down (0),
not by on/off as may be printed on the DIP switch assembly.