User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Appendix D – Abbreviation List
AGC Automatic Gain Control
AIS Alarm Indication Signal
ANEG Auto Negotiation
ATPC
Automatic Power Control
ATU
Table of MAC addresses
BER Bit Error Rate
BNC Bayonet Neill-Concelman
CPU Central Processing Unit
CRC Cyclic Redundancy Check
DC Direct Current
FEC Forward Error Correction
FER Frame Error Rate
HSI High Speed interface
IDU Indoor Unit
IF Intermediate Frequency
LAN Local Area Network
MSE Mean Square Error
NAT Network Address Translation
NMS Network Management System
ODU Outdoor Unit
PBPS Packet Based Priority System
PC Personal Computer
RFI Radio Frequency Interface
RSL Received Signal Level
RSSI Received Signal Strength Indication
SNMP Simple network management protocol
VLAN Virtual Local Area Network
Tsunami™ GX800 Installation and Management Guide 76