User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Temp : 43.0C
RX_PWR(dBm): -55
T/R value : -1010.000
Tx f band : 1918419687
RSSI (dBm) : -54.8
ok - status of command sh rad st
ok - status of command sh hsi delayed
xxx\#run fd - records factory default configuration (does not change settings)
xxx\#run w0 - records saved configuration of device after reset
xxx\#run w1 - records saved configuration of device from w1(-3) position
xxx\#run auto - automatic update of configuration (run w0) after 6 minutes (enable
timeout) since last adjusting command (turning-off “run noauto”, or
“exit”).
xxx\#write w0 - Saves configuration with IP settings
xxx\#write w1 - Save configuration without IP settings
Tsunami™ GX800 Installation and Management Guide 72