User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Chapter 6 - Technical Parameters
General
Item Parameter Value
Frequency Operating Frequency Range 6 to 38 GHz
Frequency Plans According to CEPT/ITU-R recommendations
T/R Spacing According to CEPT/ITU-R recommendations
Modulation Modulation Schemes QPSK, 16QAM, 32QAM, 64QAM, 128QAM, 256QAM
ACM Three step adaptive modulation (user-defined)
CEPT/ETSI Bandwidths 7/14(13.75)/28(27.5)/56 MHz
ANSI/FCC Bandwidths 10/20/30/40/50 MHz
Data
Transmission
Capacity Allocation Packet transport (priority based packet system)
Path Configuration 1+0
Forward Error Correction FEC, Predistortion, Equalization, Internal BER
Compression Function Online Ethernet header compression
Frequency Bands
Transmit Range
1
T/R Spacing Bandwidth
Minimum (MHz) Maximum (MHz) (MHz) (MHz)
6 GHz
5915.55 5989.675 252.04 74.125
6167.59 6241.715 252.04 74.125
5974.85 6048.975 252.04 74.125
6226.89 6301.015 252.04 74.125
6034.15 6108.275 252.04 74.125
6286.19 6360.315 252.04 74.125
6093.45 6167.575 252.04 74.125
6345.49 6419.615 252.04 74.125
5850 5946 300 96
6150 6246 300 96
5918 6014 300 96
6218 6314 300 96
5986 6082 300 96
6286 6382 300 96
6054 6150 300 96
6354 6450 300 96
6540 6600 160 60
6700 6760 160 60
6580 6640 160 60
Tsunami™ GX800 Installation and Management Guide 54