User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
The figure below indicates the IP settings for both the IDUs. The device A is in the subnet
10.11.12.xx/24 and the device B is in the subnet 10.11.13.xx/24.
The example of adding NAT and route rules is shown in the following figure.
Tsunami™ GX800 Installation and Management Guide 49
Figure 46: Out-of-Band Management over Fast Ethernet Port
Figure 47: IP setup for device A (left) and device B (right)