User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
brought via the common Gigabit cable from the external Ethernet switch to IDU (see IDU1 and
IDU2 in Figure 44 below).
Given below is an example which illustrates the connection of individual management ports in the
IDUs along with the method to configure IP settings of both the IDUs.
Out-of-Band Management through Fast Ethernet Port – Access from one
side
Another option is to supervise the entire system from one side of the GX800 link separately from
the user data through Fast ETHERNET port. The management data are brought independently
from user data into the management port in IDU. Connect management PC into the Fast
ETHERNET port on side A.
Given below is an example which illustrates the connection of individual management ports in the
IDUs along with the method to configure IP settings of both the IDUs.
Tsunami™ GX800 Installation and Management Guide 47
Figure 44: In-Band Management through Gigabit Ethernet Port