User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Compare the SN of IDU with license key which appear as: licxxxxxxxxxxxxxxxx.afw
The string of “x” is the serial number of device for which the license key is generated.
The license upgrade is performed the same way as firmware upgrade described above.
Restart the IDU after the license upgrade. To restart, navigate to main menu “Maintenance” and
sub-menu “Miscellaneous” and click REBOOT.
Alarms
GX800 generates the error messages (events) indicating its status and events. You can use an
SNMP application to get these messages and events so that you can monitor your link or
network.
Tsunami™ GX800 Installation and Management Guide 44