User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
4. Alternatively, navigate to main menu “Maintenance” and sub-menu “FW Upgrade”, and
select the file patch001.afw (if it is required) and increase the maximum limit size for the
file upload.
5. Navigate to main menu “Maintenance” and sub-menu “FW Upgrade” and choose one of
the following steps:
• Select the file fw_all.afw from the provided software package. The entire file will
be uploaded into the device, compares the different versions and writes the
different parts of the firmware into flash memory. Please note that this procedure
is not suitable for slow connections.
• Gradually select the files hwbase.afw, oskernel.afw, dev.afw and fwbase.afw in
this order (if there is not necessary to upload any part, please continue with
another file) and wait for the process completion.
6. Once the files are uploaded, restart the device by navigating to main menu
“Maintenance” sub-menu “Miscellaneous” and click REBOOT. Please note that while
restart there is data transmission outage for about 35 seconds.
!! Note !! Upgrade the firmware files in both the terminals.
To view firmware details, navigate to main menu “General” and sub-menu “Revision”.
Tsunami™ GX800 Installation and Management Guide 42
Figure 40: Alert Window for Firmware Upload
Figure 41: Firmware Revision