User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Before the pause at remote side elapses, click Mute ODU on local side for a specified period of
time (example 150 seconds) and wait for the analyze to finish. After that, the units should
interconnect again and the management of remote unit will be possible again. Finally, check the
frequency analyze at remote side.
!! Note !! Spectrum analysis for licensed bands last approximately for 150 seconds.
During this time, no data passes through the link.
Firmware Upgrade, License Upgrade
!! Note !! An ADMIN user alone can upgrade the firmware and the license.
For every firmware release, it is not necessary to update all the parts, but only the ones which
require an upgrade.
Basic Firmware Parts:
• hwbase.afw – Software for internal hardware parts
• oskernel.afw – Operating system
• dev.afw – Drivers for the Operating System
• fwbase.afw – Application software (WEB, SNMP, commands and so on)
Additional Firmware Parts:
• patch001.afw – Patch for enhancing the maximum length of the uploaded file. Applicable
for firmware upgrades from versions 0208_02 onwards.
• checkversions.afw – Compares the firmware version with the newest version and prints
the info that is necessary to upload.
• fw_all.afw – Compares the current version of firmware with the newest version and
automatically uploads the different parts (used only from firmware 0208_02 or package
patch001.afw).
Recommended Steps for Firmware Upgrade:
1. Log on to the web browser with ADMIN rights.
2. Click “COMMIT” (available on the top-right corner of each page) to save the current
configurations. Alternatively, you can save the configured parameters by navigating to
main menu “Maintenance” and sub-menu “Write” , and click “Write_WO”. By doing so,
the configurations are stored in the start-up memory.
3. Compare currently running versions of each firmware parts (oskernel.afw, dev.afw,
hwbase.afw and fwbase.afw) with the newest version by following one of the two below
steps:
• Manually compare data shown in main menu “General” and sub-menu
“Revision” with the file version.txt.
• Navigate to main menu “Maintenance” and sub-menu “FW Upgrade”, and
select the file checkversions.afw. Take a print-out and check the parts that
need to be upgraded.
Tsunami™ GX800 Installation and Management Guide 41