User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Next, click Analyze to start the spectrum analysis at the local terminal. In licensed bands, the
Analyze over whole band option causes analysis through the whole spectrum with a wider
frequency spacing (14MHz), otherwise the analysis is made in 56MHz range only around the RX
frequency with spacing 3.5MHz.
Frequency Analysis at Remote Side:
It is also possible to set a pause before scanning the spectrum. This is suitable for analyzing the
remote device. Set the pause (for example 10 seconds and click Analyze at remote side – this
will disconnect the management between the terminals and start the analysis after the specified
period of time (pause).
Tsunami™ GX800 Installation and Management Guide 40
Figure 39: Spectrum Analyzer Setup and Output