User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Chapter 1 - Introduction
About Tsunami™ GX800
Tsunami
TM
GX800 is a licensed microwave Point-to-Point link with up to 600Mbps aggregate
throughput with ultra low latency of 100μs offering unparalleled capacity and reliability for
Carriers, Service Providers and Enterprise Markets. It supports a wide frequency bands from 6-
38 GHz with range of user configurable channel bandwidths from 7-56 MHz to match licensing
regulations. The product has an extremely small foot print and is designed with a split-mount
architecture which includes an Outdoor Unit (ODU) and a Compact Indoor Unit (IDU) that are a
snap to install and easy to maintain.
Device Features
The features of the device are as follows:
• Supports wide frequency bands from 6 – 38 GHz with range of user configurable channel
bandwidths from 7 - 56 MHz to match licensing regulations
• Supports QPSK/16QAM/32QAM/64QAM/128QAM/256QAM Modulation schemes along
with user-defined Adaptive Coding and Modulation (ACM)
• Features built-in Spectrum Analyzer for interference avoidance, Built-in Bit Error Rate
(BER) tester, Automatic Transmit Power Control (ATPC) and Adaptive Coding Modulation
(ACM) for the best throughput performance
• User traffic interface with Gigabit Ethernet port for data payload
• User/Management traffic interface with fast Ethernet port for Data and/or Network
Management System (NMS)
• High Speed Interface 2xE1/T1 or E3/DS3 extension module
• Forward error correction (Reed-Solomon/ Convolutional/ Pragmatic Trellis/ Parity Check
code)
• Adjustable output power in the range -10dBm to +26 dBm according to the set frequency
and the selected modulation scheme
• Device management through Telnet, HTTP and SNMP
Tsunami™ GX800 Installation and Management Guide 4