User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Analysis of Interference in GX800 link
Integrated Spectral Analyzer is a suitable tool for finding free channels in a given frequency band,
eventually for link interference. For licensed bands, you can use the Analyzer for the free
frequency verification.
Spectrum Analyzer is available in ADMIN and USER mode.
Frequency Analysis at Local Side:
Before finding if the given frequency spectrum is free or occupied, you have to mute the
transmitter on one side (ideally remote side). Exercise care as this will cause drop out of user
data transmission.
Login to remote device and mute the transmitter for a specified period of time with an automatic
revival. The interval for mute could be set from 1 to 3600 seconds. The remote unit will start
transmitting again automatically as the specified time elapses.
Navigate to main menu “Radio” and sub-menu “Analyzer”, and enter the time in seconds and
click Mute ODU button.
Tsunami™ GX800 Installation and Management Guide 39