User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Check the box T1_1 to map available T1_1 channel onto T1 port. The T1 signal then takes
1.55Mbps from overall available user data rate. Remaining 155.44Mbps is allocated to Ethernet
data. (Make sure “rfi” option is selected.)
Set Ethernet LAN SPEED to 200 Mbps (the remaining capacity (155.44Mbps) will be allocated to
Ethernet data)
In the similar way, set the same values on the other side of the link.
Click “Apply” to commit the configured values.
Click “COMMIT” to save the configured parameters.
Tsunami™ GX800 Installation and Management Guide 34
Figure 34: Setting Connection Data Channels