User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Example 1
For Ethernet transmission, with a modulation scheme 128QAM and bandwidth 28MHz, the real
user data rate is 156.99Mbps and the real data throughput is 163.24Mbps.
In the Web Browser, navigate to main menu “Ports” and sub-menu “Parameters” and set the
LAN SPEED as 200 Mbps (the overall capacity is allocated to Ethernet data, which is
156.99Mbps; no other interface is detected).
In the similar way, set the same values on the other side of the link.
Example 2
For Ethernet + 1xT1 transmission, with a modulation scheme 128QAM and bandwidth 28MHz,
the real user data rate is 156.99Mbps and real data throughput is 163.24Mbps.
The inserted HSI module is automatically detected and displayed with graphical interconnection
between PORTS and available RFI MUX channels as shown in the following figure.
Tsunami™ GX800 Installation and Management Guide 33
Figure 33: Data Rate