User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Adaptive Modulation Setup
ACM can be set by using the following three options:
• Adaptive Modulation 0 (ACM0) is for the highest throughput and the lowest security
• Adaptive Modulation 1 (ACM1) and 2 (ACM2) for the lower data throughput and better
security.
The desired ACM steps should be set at least in two fields ACM0 – ACM1 (see the following
figure). A user is allowed to set the ACM only when the Enable ACM box is unchecked. This
guarantees that the Actual Modulation setup could not be performed manually during the active
ACM.
Tsunami™ GX800 Installation and Management Guide 30
Figure 30: Modulation Setup without ACM