User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Click Write_and_Reload to save the new configuration parameters onto Write_W0 startup
memory.
!! NOTE !! Proxyarp feature is accessible in ADMIN mode only.
!! ATTENTION !! Any change or modification in the IP setting takes effect only after saving
the configuration to “Write_W0” memory followed by device restart.
Interconnection of LAN A-B Ethernet Switches
For management through the Gigabit Ethernet port, it is necessary to enable (check) the
interconnection of LAN A-B switches in both IDUs and set a minimum data rate (1Mbps) on
Ethernet. To configure this setting, navigate to main “Ports” and sub-menu “Parameters”.
In the above screen, do the following:
1. Check LAN A-B switch
2. Enter Ethernet speed (example 200Mbit) in the LAN SPEED box
3. Click Apply.
4. Click “COMMIT” to save the configured parameters.
Configure the same settings on the remote IDU2 as well.
Tsunami™ GX800 Installation and Management Guide 27
Figure 28: Enabling LAN A-B Ethernet Switches