User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
For example, a device in the network has IP 192.168.3.0/24, gateway 192.168.3.1. The
management data can be transmitted together with the user data through the common cable
connected from the same switch into single Gigabit Ethernet port (port for user data).
After configuring the IP settings, click Apply. The following alert screen appears:
Tsunami™ GX800 Installation and Management Guide 26
Figure 25: IP Address
Figure 27: IP Configuration Change Window
Figure 26: IP setup for device A (left) and device B (right)