User's Manual

The following alert message is displayed, when a user is already logged in and an Administrator
tries to login.
Restore Defaults
To restore the default access names and passwords (admin/secret, user/test, guest/-) including
the secondary IP address, follow any one of the below methods:
• Restore using RS232 Console:
• Establish a serial connection
• Enter Login name as default
• Enter Password as restore. Please note that password should be written within
two minutes of providing the user name.
• On providing the correct user name and password, the user is immediately
disconnected and passwords along with the IP address are restored.
• Restore using USB Flash:
• Check the SN number of the IDU
• Copy the rfwATH.afw file (or appropriate file) on USB disk into directory
“/restoreFW” and rename this file to “rfwSN.afw”, where the SN is the serial
number of the IDU.
• Turn off the IDU
• Turn on the IDU
• Wait for the LED to blink during the boot process
• Insert USB disk into port USB A
• Wait for 1 minute until the process termination (the indication LED on USB disk
should blink during this process)
Configure, Manage and Monitor using Web Browser
Open a web browser and log on to the device by entering http://10.0.0.1 for A-side and
http://10.0.0.2 for B-Side in the address bar. The Login screen appears.
The login section is active until the logout. It is not possible to configure the IDU from two
terminals at the same time (only one terminal can be active in the setup (enable) mode), that is
the user with access rights User or Administrator.
Tsunami™ GX800 Installation and Management Guide 23
Figure 23: Login Screen
Figure 22: Admin Login – Alert Window