User's Manual

Chapter 4 - Commissioning
Introduction
After the installation of the link, it is necessary to carry out the complete setup of all the required
link parameters including IP management. It is recommended to save the parameters such as IP
addresses, Tx Frequency, Tx Power as these parameters can be restored easily in case of the
device replacement.
This section covers the method to set up GX800 link by using Web Interface. The link setup by
using text commands is covered in Appendix A – Command Set.
Access Rights
Log on to the GX800 link system, either locally or remotely to mange and monitor the link. Based
on the type of user logged in, relevant access rights are automatically granted to the user. These
access rights are applicable both in web and command line interfaces.
GX800 supports three levels of login modes.
Guest
A Guest user can,
• Monitor the traffic on the GX800 link, the Quality of the frequency tuning and the
configured parameters of the link (Tx Power and so on)
• Clear BER tester and so on
The link system supports a maximum of three guest user logins at the same time. The login
name is guest. Please note that a Guest can login without a password.
User
A User has the same access rights as the Guest user, with additional rights to configure and set
the GX800 link parameters. The link system supports only one User login at the same time. With
User logged in, a maximum of three Guest users can login to monitor the device.
The login name is user and password is test.
Administrator
An Administrator has the same rights as that of the Guest and User, with additional rights to
upload a new firmware, control user's database, and change the user name and password.
Administrator user posses the superior level of user access and management of the link. When
the administrator user logs in, all the other users are logged out automatically.
The login name is admin and password is secret.
Tsunami™ GX800 Installation and Management Guide 22