User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Connecting IDU to External Equipments
Connecting External Equipments through HSI port
Depending on the configuration (customer´s order) the IDU is equipped with specific HSI module.
To extend the functionality of GX800 system with 1-2 E1/T1 ports, use IDU configuration with
inserted HSI-2E1/T1 module. You can directly connect to a maximum of two E1/T1 lines or
devices through RJ48 connector.
To extend the functionality of GX800 system with 1 E3/DS3 (G.703) ports, use IDU configuration
with inserted HSI-E3/DS3 module.
Tsunami™ GX800 Installation and Management Guide 21
Figure 20: HSI 2xE1/T1 Module
Figure 21: HSI E3/DS3 Module