User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
5. You are now prompted to Write and Reload the device. Click Write_and_Reload for the
IP change to take effect.
6. Log back into the device by using either the Primary or Secondary IP address.
7. Navigate to the Radio tab and perform the following:
• Under ODU Configuration, verify if Tx and Rx center frequencies match your
license.
• Under Modem Configuration, select the Modulation and Channel Bandwidth in
accordance with the link design and licensed operation.
• If you are using Adaptive Modulation, check the Enable ACM box and
select the appropriate High, Mid, Low modulation settings.
• Click Apply.
8. When you complete all the settings, click COMMIT on the upper right corner of the
Tsunami™ GX800 Installation and Management Guide 17
Figure 15: Save IP Configuration
Figure 16: Radio Settings