User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Basic Configuration
For the initial configuration, use a Personal Computer (PC) with an Ethernet interface, and
current Web Browser (Mozilla, Internet Explorer, Chrome and so on). The operator should have
administrative rights on the PC, with the ability to change the adapters IP address and other
interface settings.
Follow the following steps to perform basic configuration of the device:
1. First set your computer's IP address to the range which corresponds to the default IDU
factory setup. Each IDU unit has the pre-set primary IP address 10.0.0.1 for A-side or
10.0.0.2 for B-side with the network mask 255.255.255.0. Therefore it is necessary to set
the IP address of your computer in the same range of 10.0.0.3 - 254, except for the
device IP address. Configure your computer's IP address (For example 10.0.0.3) and
subnet to 255.255.255.0.
2. The Login screen appears. Open a web browser and log on to the device by entering
http://10.0.0.1 for A-side and http://10.0.0.2 for B-Side in the address bar. The Login
screen appears.
3. In the Login Screen, enter the User Name and Password and then click Login. For user
Tsunami™ GX800 Installation and Management Guide 15
Figure 12: Login Screen
Figure 11: Configure PCs IP Address