User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
!! ATTENTION !!
• Do not plug in ODU while IDU is powered on as this may damage the ODU.
• Before connecting the coaxial cable to the ODU and IDU, please measure the cable
impedance or measure the cable adjustment.
Connect to the Gigabit Ethernet Port
To manage the entire system (link), plug in the Ethernet cable into the 10/100/1000 Gigabit
Ethernet Port of the IDU. The connector wiring is shown below.
!! Note !! Before connecting the Ethernet cable to 10/100/1000 Gigabit Ethernet port, make
sure that the Ethernet cable is not connected to the 10/100 Fast Ethernet Port.
Connect to the Fast Ethernet Port
For primary configuration and to manage the entire system (link), plug in the Ethernet cable into
the 10/100 Fast Ethernet Port of the IDU. The connector wiring is shown below.
Tsunami™ GX800 Installation and Management Guide 13
Figure 7: IDU - ODU Cabling
Figure 8: Pin Assignments for Gigabit Ethernet Port
Pin 1 - DA+, Pin 2 - DA-
Pin 3 - DB+, Pin 6 - DB-
Pin 4 - DC+, Pin 5 - DC-
Pin 6 - DD+, Pin 7 DD-
8
1