User's Manual
Table Of Contents
- Chapter 1 - Introduction
- Chapter 2 – Hardware Overview
- Chapter 3 – Installation and Initialization
- Chapter 4 - Commissioning
- Introduction
- Access Rights
- Restore Defaults
- Configure, Manage and Monitor using Web Browser
- General Screen
- IP Address Setup
- Dual License - Design Type Setup
- Frequency, Modulation and ATPC Setup
- Ethernet Advanced Configuration
- Data Rate Settings for Connected User Interfaces
- Save Configured Parameters
- BER Test – GX800 Link and User Lines Verification
- Analysis of Interference in GX800 link
- Firmware Upgrade, License Upgrade
- Alarms
- SNMP Settings
- IP Management
- Chapter 5 – Troubleshooting
- Chapter 6 - Technical Parameters
- Chapter 7 - Appendix
Chapter 3 Installation and Initialization
Introduction
The device must be installed either by a trained professional familiar with radio frequency
planning and the regulatory limits. The equipment must be installed in accordance with the
country national electrical codes.
Required Installation tools
Listed below are the installation tools necessary for installation of the GX800 link. These are not
included in the product package:
• Flat tip Screwdriver
• Cross Screwdriver
• Set of Allen Keys
• Engineer´s Wrench M7, M13, M17
• Vulcanize Isolation Tape
• DC Voltmeter
• BNC Reduction for RSSI Measurement
IDU Installation
The IDU is designed to mount to a standard 19-inch cabinet.
Single IDU Installation
To rack-mount a single IDU, follow the following steps:
1. Fix the small L-shaped clamp (supplied with the product package) to any one side of the
IDU with the provided screws and washers.
2. On the other side of the IDU, fix the big L-shaped clamp (supplied with the product
package) with the provided screws and washers.
3. Next, fix the IDU to the rack.
Pair of IDUs Installation
To rack-mount a pair of IDUs, follow the following steps:
Tsunami™ GX800 Installation and Management Guide 10
Figure 3: Single IDU Mounting