User's Manual

shared among all clients and Access Points in a wireless network. The ESSID must be
identical for all clients or Access Points participating in the same network. The ESSID
is case sensitive and must not exceed 30 characters. Pressing ‘ Rescan,’ will scan all
the APs in the nearby area and choose the strongest one. Using “Link Quality” and
“Signal Strength”, you can determine the wireless transmission quality.
Press ‘ Config Adapter’ tab, then you will see the screen below.
There are two network types:
Ad-Hoc: This mode is used for a simple peer-to-peer network. It offers file sharing
between wireless clients without a wireless Access Point (AP).
Infrastructure (Default): This mode allows a wireless LAN to be integrated into an
existing wired network through an AP. Infrastructure type networks also permit
roaming between Access Points while maintaining connection to all network
resources. Infrastructure mode provides additional features, such as WEP security,
power saving and extended range.
ESSID: You can either choose specific AP or connect to any AP in the nearby area.
Power Save: enable it, so it will be triggered when your computer system is inactive.
After computer system active again, wireless connection will rebuild.