User's Manual
Table Of Contents
- Welcome
- Preparing for Installation
- Determine Range & Clearance
- Installing the Antenna
- The Antenna Cabling System
- 14 dBi Directional Antenna
- 7 dBi Omni-Directional Base Station Antenna
- 10 dBi Omni-Directional Base Station Antenna
- 12 dBi Directional Wide Angle Antenna
- 24 dBi Directional Parabolic Grid Antenna
- Certified Outdoor Solutions
- Support & Warranty
- Index
- List of Figures
- List of Tables
ORiNOCO Outdoor Antenna Installation Guide D-1
10 dBi Omni-Directional
Base Station Antenna
Hardware Specifications
The Lucent Technologies 10 dBi Omni-Directional Base Station Antenna is a
broadband antenna for the 2.4 GHz frequency band featuring an omni-
directional pattern with a nominal gain of 10 dBi.
This antenna is typically used in combination with ORiNOCO/Centrals in Master
mode.
The pole-type antenna is enclosed in a weatherproof protective covering
(“radome”). This vertically polarized antenna can be mounted to an antenna
mast with an outside diameter of up to 51 mm (2.0 in).
For detailed specifications see Table D-1 on page D-2.
!
CAUTION:
When selecting an antenna location, please ensure general precautions
so as to avoid possible contact with electrical power lines. Refer to the
National Electrical Code for proper grounding of the antenna mast.
Mounting Instructions
1. Attach the ferrule of the antenna to the mounting bracket with two u-bolts as
shown inFigure D-1 on page D-2.
2. Next use the remaining two u-bolts to attach the mounting bracket to the
mast. Tighten nuts to 9 Nm (7 ft.-lbs).
3. Proceed with “Connecting the Antenna Cable” on page 4-6 to connect the
antenna to the indoor equipment and seal the antenna connectors.