User's Manual

Advanced Configuration AP-700 User Guide
Interfaces
56
channel is blacklisted automatically if it is found to be busy or occupied by radar during a scan at start-up. When a
channel has been automatically blacklisted, it will remain blacklisted for 30 minutes. Additionally, an administrator can
blacklist channels manually to prevent them from being used when ACS is enabled. To blacklist a channel manually:
1. Click on Configure > Interfaces > Wireless A.
2. Scroll down to the Channel Blacklist heading.
Figure 4-11 Channel Blacklist Table
3. Click Edit in the Channel Blacklist Table
4. Set Blacklist Status to Enable.
Figure 4-12 Channel Blacklist Table - Edit Screen