User Manual
Table Of Contents
- Contents
- Introduction
- Installation & Basic Configuration
- Status Information
- Advanced Configuration
- Configuring the AP-600 Using the HTTP Interface
- System
- Network
- Interfaces
- Management
- Filtering
- Ethernet Protocol
- Static MAC
- Static MAC Filter Examples
- Prevent Two Specific Devices from Communicating
- Prevent Multiple Wireless Devices From Communicating With a Single Wired Device
- Prevent All Wireless Devices From Communicating With a Single Wired Device
- Prevent A Wireless Device From Communicating With the Wired Network
- Prevent Messages Destined for a Specific Multicast Group from Being Forwarded to the Wireless LAN
- Static MAC Filter Examples
- Advanced
- TCP/UDP Port
- Alarms
- Bridge
- Security
- RADIUS
- Monitor Information
- Commands
- Troubleshooting
- Troubleshooting Concepts
- Symptoms and Solutions
- Recovery Procedures
- System Alarms (Traps)
- Related Applications
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables & User Strings
- Configuring the AP-600 using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Other Network Settings
- Configure the AP-600 as a DHCP Server
- Configure the DNS Client
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Autochannel Select (ACS)
- [Device Name]>set wif 3 autochannel
[Device Name]>reboot 0 - Enable 2X Turbo Mode (AP-600a Only)
- [Device Name]>set wif 3 turbo
[Device Name]>reboot 0 - Enable/Disable Interference Robustness (AP-600b Only)
- Enable/Disable Closed System (AP-600b Only)
- Enable/Disable Load Balancing (AP-600b Only)
- Enable/Disable Medium Density Distribution (AP-600b Only)
- Set the Distance Between APs (AP-600b Only)
- Set the Multicast Rate (AP-600b Only)
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure MAC Access Control
- Configure 802.1x Authentication
- Set RADIUS Parameters
- CLI Monitoring Parameters
- Parameter Tables
- ASCII Character Chart
- Specifications
- Technical Support
Commands
80
Reset
Use the Reset tab to restore the AP-600 to factory default conditions. The AP-600 may also be reset from the RESET
button located on the side of the unit. Since this will reset the Access Point’s current IP address, a new IP address
must be assigned. Refer to Recovery Procedures for more information.
&$87,21
&$87,21&$87,21
&$87,21
!
Resetting the AP-600 to its factory default configuration will permanently overwrite all changes that have made
to the unit. The AP-600 will reboot automatically after this command has been issued.
Figure 6-6 Reset to Factory Defaults Command Screen
Help Link
To open Help, click the Help button on any display screen.
During initialization, the AP-600 on-line help files are downloaded to the default location:
C:\Program Files\ORiNOCO\AP600\Help\English\index.htm
.
The ORiNOCO AP-600 Help information is available in English, French, German, Italian, Spanish, and Japanese. The
Help files are copied to your computer in all six languages. To update the Help link to use a different language, enter
the appropriate path in the Help Link box. For example, to change to the French Help file, enter
C:\Program Files\ORiNOCO\AP600\Help\French\index.htm
.
If you want to place these files on a shared drive, copy the Help Folder to the new location, and then specify the new
path in the Help Link box.
Figure 6-7 Help Link Configuration Screen