User Manual

Installation & Basic Configuration
32
LED Indicators
The AP-600 has four LED indicators. The LEDs are identified in LED Indicators Illustrated and exhibit the following
behavior:
Figure 2-16 LED Indicators Illustrated
Related Topics
The Setup Wizard helps you configure the basic AP-600 settings required to get the unit up and running. The AP-600
supports many other configuration and management options. The remainder of this user guide describes these options
in detail.
– See Advanced Configuration for information on configuration options that are available within the Access Point’s
HTTP interface.
– See Monitor Information for information on the statistics displayed within the Access Point’s HTTP interface.
– See Commands for information on the commands supported by the Access Point’s HTTP interface.
– See Troubleshooting for troubleshooting suggestions.
– See Command Line Interface (CLI) for information on the CLI interface and for a list of CLI commands.
Power Ethernet Link Ethernet Activity Wireless Activity Indication
Solid Green Green when link
exists
Green flash
with data activity
Green flash
with data activity
Normal Operation
Solid Amber Solid Amber Solid Amber Solid Amber Rebooting
Solid Green Solid Amber Solid Amber Solid Amber Reset to Factory Defaults command issued
Solid Red Off Off Off SDRAM Test Failure
Blinking Red Blinking Red or Off Blinking Red Off Hardware Timer Test Failure
Blinking Red Off Off Blinking Red Flash Test Failure
Solid Red Blinking Red or Off Solid Red Off Ethernet Test Failure
Solid Red Off Off Solid Red Wireless Test Failure
Blinking Amber Blinking Amber or Off Blinking Amber or Off Off Missing or bad AP image
Solid Amber Solid Amber Solid Amber Solid Amber Missing or bad bootloader image (all LEDs
remain solid amber)
n/a n/a n/a Red Wireless radio is not working properly
n/a n/a Amber Amber Indicated interface in administrative down state
Power LED
Wireless Activity LED
Ethernet Activity LED
Ethernet Link LED