User Manual

Command Line Interface (CLI)
124
Intra BSS Subscriber Blocking
The following parameters control the Intra BSS traffic feature, which prevent wireless clients that are associated with
the same AP-600 from communicating with each other:
Packet Forwarding Parameters
The following parameters control the Packet Forwarding feature, which redirects wireless traffic to a specific MAC
address:
127(
127(127(
127(
The Wireless Distribution System (WDS) feature is not available for the AP-600a at this time.
Security Parameters
Wireless Interface Security Parameters
The following table details the WEP encryption parameters for the AP-600 (both the AP-600a and the AP-600b).
Name Type Values Access CLI
Intra BSS Traffic Group N/A R intrabss
Intra BSS Traffic
Operation
Integer passthru (default)
block
RW intrabssoptype
Name Type Values Access CLI
Packet Forwarding MAC
Address
Group N/A R pktfwd
Packet Forwarding MAC
Address
MacAddress User Defined RW pktfwdmacaddr
Packet Forwarding
Status
Integer enable
disable (default)
RW pktfwdstatus
Packet Forwarding
Interface Port
Integer 0 (any) (default)
1 (Ethernet)
3 (WDS 1)
4 (WDS 2)
5 (WDS 3)
6 (WDS 4)
7 (WDS 5)
8 (WDS 6)
RW pktfwdif
Name Type Values Access CLI Parameter
Security Group N/A R security
Configuration Mode Integer none (default)
802.1x
mixed
RW secconfig
Re-keying Interval Integer 60 – 65535 seconds
default is 900 sec
RW secrekeyint
Name Type Values Access CLI Parameter
Wireless Interfaces
Security
Group R wifsec
Encryption Status Integer enable
disable (default)
RW encryptstatus
Index Integer 3 R index
Encryption Key 1 DisplayString User Defined W encryptkey1
Encryption Key 2 DisplayString User Defined W encryptkey2
Encryption Key 3 DisplayString User Defined W encryptkey3
Encryption Key 4 DisplayString User Defined W encryptkey4
Deny non-encrypted
Data
Integer enable (default)
disable
RW encryptdeny
Data Transmission
Encryption Key
Integer 1 (default)
2
3
4
RW encryptkeytx