User Manual

Command Line Interface (CLI)
113
System Parameters
Inventory Management Information
127(
127(127(
127(
The inventory management commands display advanced information about the AP-600’s installed
components. You may be asked to report this information to a technical representative if you contact customer
support.
Network Parameters
IP Configuration Parameters
127(
127(127(
127(
The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipmask) or Default Gateway IP Address (ipgw) values can be entered.
Name Type Values Access CLI Parameter
System Group N/A R system
Name DisplayString User Defined RW sysname
Location DisplayString User Defined RW sysloc
Contact Name DisplayString User Defined RW sysctname
Contact E-mail DisplayString User Defined RW sysctemail
Contact Phone DisplayString User Defined
max 254 characters
RW sysctphone
FLASH Backup Interval Integer 0 - 65535 seconds RW sysflashbckint
Flash Update 0
1
RW sysflashupdate
System OID DisplayString N/A R sysoid
Descriptor DisplayString System Name, flash
version, S/N, bootloader
version
R sysdescr
Up Time Integer dd:hh:mm:ss
dd – days
hh – hours
mm – minutes
ss – seconds
R sysuptime
Emergency Restore to defaults Resets all parameters to
default factory values
RW sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
set sysresettodefaults 1
Name Type Values Access CLI Parameter
System Inventory Management Subgroup N/A R sysinvmgmt
Component Table Subgroup N/A R sysinvmgmtcmptbl
Component Interface Table Subgroup N/A R sysinvmgmtcmpiftbl
Name Type Values Access CLI Parameter
Network Group N/A R network
IP Configuration Group N/A R ip (Note: The network and
ip parameters display the
same information)
IP Address IpAddress User Defined RW ipaddr
IP Mask IpAddress User Defined RW ipmask
Default Router IP Address IpAddress User Defined RW ipgw
Default TTL Integer User Defined (seconds)
64 (default)
RW ipttl
Address Type Integer static
dynamic (default)
RW ipaddrtype