User Manual

Command Line Interface (CLI)
112
Parameter Tables
Objects contain groups that contain both parameters and parameter tables.
Use the following Tables to configure the Access Point. Columns used on the tables include:
— Name - Parameter, Group, or Table Name
— Type - Data type
— Values - Value range, and default value, if any
— Access = access type, R = Read Only (show), RW = Read-Write (can be “set”), W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
• System Parameters - Access Point system information
– Inventory Management Information - Hardware, firmware, and software version information
• Network Parameters - IP and Network Settings
– IP Configuration Parameters - Configure the Access Point’s IP settings
— DNS Client for RADIUS Name Resolution - Configure the Access Point as a DNS client
– DHCP Server Parameters - Enable or disable dynamic host configuration
– Link Integrity Parameters - Monitor link status
• Interface Parameters - Configure Wireless and Ethernet settings
– Wireless Interface Parameters
— Wireless Distribution System (WDS) Parameters (AP-600b Only) - Configure the WDS partnerships
– Ethernet Interface Parameters - Set the speed and duplex of the Ethernet port
• Management Parameters - Control access to the AP-600’s management interfaces
– SNMP Parameters - Set read and read/write passwords
– HTTP (web browser) Parameters - Set up the graphical web browser interface
– Telnet Parameters - Telnet Port setup
– Serial Port Parameters - Serial Port setup
– TFTP Server Parameters - Set up for file transfers; specify IP Address, file name, and file type
– IP Access Table Parameters - Configure range of IP addresses that can access the AP-600
• Filtering Parameters
– Ethernet Protocol Filtering Parameters - Control network traffic based on protocol type
– Static MAC Address Filter Table - Enable and disable specific addresses
– Proxy ARP Parameters - Enable or disable proxy ARP for wireless clients
– IP ARP Filtering Parameters - Control which ARP messages are sent to wireless clients based on IP settings
– Broadcast Filtering Table - Control the type of broadcast packets forwarded to the wireless network
– TCP/UDP Port Filtering - Filter IP packets based on TCP/UDP port
• Alarms Parameters
– SNMP Table Host Table Parameters - Enter the list of IP addresses that will receive alarms from the AP-600
– Syslog Parameters - Configure the AP-600 to send Syslog information to network servers
• Bridge Parameters
– Spanning Tree Parameters - Used to help prevent network loops
– Storm Threshold Parameters - Set threshold for number of broadcast packets
– Intra BSS Subscriber Blocking - Enable or disable peer to peer traffic on the same AP
– Packet Forwarding Parameters - Redirect traffic from wireless clients to a specified MAC address
• Security Parameters - Access Point security settings
– Wireless Interface Security Parameters - Configure WEP encryption settings
– MAC Access Control Parameter - Control wireless access based on MAC address
• RADIUS Parameters
– Primary and Backup RADIUS Server Table Parameters - RADIUS Authentication and Accounting information
• Other Parameters
– IAPP Parameters - Enable or disable the Inter-Access Point Protocol
– SpectraLink VoIP Parameters (AP-600b Only) - Enable or disable SpectraLink Voice over IP feature