User Manual
Table Of Contents
- Contents
- Introduction
- Installation & Basic Configuration
- Status Information
- Advanced Configuration
- Configuring the AP-600 Using the HTTP Interface
- System
- Network
- Interfaces
- Management
- Filtering
- Ethernet Protocol
- Static MAC
- Static MAC Filter Examples
- Prevent Two Specific Devices from Communicating
- Prevent Multiple Wireless Devices From Communicating With a Single Wired Device
- Prevent All Wireless Devices From Communicating With a Single Wired Device
- Prevent A Wireless Device From Communicating With the Wired Network
- Prevent Messages Destined for a Specific Multicast Group from Being Forwarded to the Wireless LAN
- Static MAC Filter Examples
- Advanced
- TCP/UDP Port
- Alarms
- Bridge
- Security
- RADIUS
- Monitor Information
- Commands
- Troubleshooting
- Troubleshooting Concepts
- Symptoms and Solutions
- Recovery Procedures
- System Alarms (Traps)
- Related Applications
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables & User Strings
- Configuring the AP-600 using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Other Network Settings
- Configure the AP-600 as a DHCP Server
- Configure the DNS Client
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Autochannel Select (ACS)
- [Device Name]>set wif 3 autochannel
[Device Name]>reboot 0 - Enable 2X Turbo Mode (AP-600a Only)
- [Device Name]>set wif 3 turbo
[Device Name]>reboot 0 - Enable/Disable Interference Robustness (AP-600b Only)
- Enable/Disable Closed System (AP-600b Only)
- Enable/Disable Load Balancing (AP-600b Only)
- Enable/Disable Medium Density Distribution (AP-600b Only)
- Set the Distance Between APs (AP-600b Only)
- Set the Multicast Rate (AP-600b Only)
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure MAC Access Control
- Configure 802.1x Authentication
- Set RADIUS Parameters
- CLI Monitoring Parameters
- Parameter Tables
- ASCII Character Chart
- Specifications
- Technical Support
Command Line Interface (CLI)
111
Figure A-18 Result of “show radius” CLI Command
Configure RADIUS Accounting server
[Device Name]>set radacctbl <index> status <enable> seraddrfmt <ipaddr or name> ipaddr
<RADIUS IP address or name> port <user defined> ssecret <user defined>
responsetm <1 to 4 seconds> maxretx <1 to 10 times>
[Device Name]>show radacctbl
Figure A-19 Results of “show radacctbl” CLI command
CLI Monitoring Parameters
Using the show command with the following table parameters will display operating statistics for the AP-600 (these are
the same statistics that are described in Monitor Information for the HTTP Web interface).
– staticmp: Displays the ICMP Statistics.
– statarptbl: Displays the IP ARP Table Statistics.
– statbridgetbl: Displays the Learn Table.
– statiapp: Displays the IAPP Statistics.
– statradius: Displays the RADIUS Authentication Statistics.
– statif: Displays information and statistics about the Ethernet and wireless interfaces.
– stat802.11: Displays additional statistics for the wireless interfaces.
– statethernet: Displays additional statistics for the Ethernet interface.